What a gas tightness test is, and when you need one
Updated 1 October 2026 · 2 minute read · Written by our Gas Safe engineers
If you have had a gas engineer round after a smell of gas, a new appliance or some pipework changes, you may have heard the words “tightness test”. It is the check that tells you the whole gas installation, from the meter to every appliance, is sealed.
What it involves
- Everything is turned off. Every appliance on the supply is switched off, including pilot lights.
- A gauge goes on. The engineer connects a pressure gauge to a test point on the installation, usually at the meter.
- Let-by check. The engineer first checks that the meter valve is not letting gas through when it is closed.
- The pressure is watched. The system is brought up to pressure and then watched over a set period. If the reading drops, gas is escaping somewhere.
- Finding it. If there is a drop, the engineer works along the installation to find where.
It is quiet, it is quick on most homes, and it gives a straight yes or no.
When you need one
- After a suspected leak. It is how a suspected gas leak gets confirmed or ruled out properly.
- After any work on the pipework, including capping off, extending or rerouting.
- When a new appliance goes on, as part of commissioning it.
- Before gas is turned back on after the supply has been isolated.
What it is not
A tightness test does not service your boiler, and it does not check how an appliance is burning. That is what a service and a gas safety check are for. The test is about the pipework holding gas in.
If it fails
The engineer finds the leak and puts it right, then tests again. If the fault cannot be fixed straight away, the affected part is made safe and you are told plainly what happens next. You will not be left with gas on and a leak in the system.
Local gas engineer near me for testing
We tightness test as part of our gas work across Bridgend county, the Vale, Neath and Port Talbot. If you can smell gas right now, ring 0800 111 999 first. Otherwise, message us your postcode and what is going on.
Keep reading
- How to check a local gas engineer is really Gas Safe registered Thirty seconds on the Gas Safe Register before anyone touches your boiler or hob. What to check on the ID card, what it should list, and the paperwork you should be left with.
- Smell gas? What to do first, and when to ring a gas engineer A gas smell is an emergency call, not a booking. The free number, what to do and not do, and what a local gas engineer does once the property has been made safe.
- Fitting a gas hob or cooker: why it has to be a Gas Safe engineer A new kitchen, a replacement hob or a cooker moved a few feet all count as gas work. What the job involves, what to have ready, and what you should be left with.